Dimplex LIH 10TE Instructions D'installation Et D'utilisation page 28

LIH 10TE
8 Additional model features
8.1 Type of defrosting
8.2 Condensate tray frost protection /
Water in device is protected from freezing
8.3 Max. operating overpressure (heat source/heat sink)
9 Heat output / COP
5
9.1 Heat output / COP
1. The specified sound levels apply with connected channels (2 x 90°-bend) and without the optional supporting feet.
If the supporting feet are used, the level can increase by up to 3 dB (A).
2. The specified sound pressure level corresponds to the operating noise of the heat pump in heating operation with a flow temperature of 35 ?. The specified sound pressure level
represents the free sound area level. The measured value can deviate by up to 16 dB(A) depending on the installation location.
3. An air circuit must be used for installation, which significantly reduces the specified sound power level.
4. Please note that additional space is required for pipe connections, operation and maintenance.
5. These data indicate the size and capacity of the system according to EN 14511. For an analysis of the economic and energy efficiency of the system, the bivalence point and
regulation should be taken into consideration. These specifications can only be achieved with clean heat exchangers. Information on maintenance, commissioning and operation
can be found in the respective sections of the installation and operating instructions. The specified values have the following meaning, e.g. A7 / W35: Heat source temperature 7
°C and heating water flow temperature 35 °C.
6. See CE declaration of conformity
7. The heat circulating pump and the heat pump manager must always be ready for operation.
EN-12
7
bar
at A-7 / W35 kW / ---
at A2 / W35 kW / ---
at A7 / W35 kW / ---
at A7 / W45 kW / ---
at A10 / W35 kW / ---
452165.66.01 · FD 9502
Reverse circulation
Yes
3,0
EN 14511
6,6 / 2,8
8,2 / 3,3
9,4 / 3,6
9,3 / 3,1
10,4 / 3,9
www.dimplex.de