Operation And Handing; Operating Elements And Displays; Rating Plate - CASO DESIGN WineSafe 18 EB Mode D'emploi

 This unit is not designed to be installed in an RV or used with an inverter.
 The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. Operations using an electrical outlet
without a protective conductor are prohibited. If in doubt, have the house installation
checked over by a qualified electrician. The manufacturer cannot be made responsible for
damages that are caused by a missing or damaged protective conductor.

13 Operation and Handing

This chapter provides you with important notices with regard to operating the device.

13.1 Operating elements and displays

The device transmits the following signal sounds as an acoustic feedback signal:
► Use the buttons
► Temperature recommendations: Red wine: 12°C – 16°C and white wine 6°C – 10°C.
► The display indicates the average temperature of the appliance at the moment.
If you press the power button the device starts working.
With pushing both
exchange between °C and °F.
You can set the temperature as your desire: With
temperature by 1°C among 5-20°C.
You can tune the interior light on or off by pressing the "Light" button. The light will
switch off automatically after 4 hours to save energy.
The temperature in the device depends on the room temperature, the quantity of bottles and
the chosen temperature. Please note that your device is intended to cool wine. The
maximum temperature that can be reached inside the device cannot be significantly ABOVE
the ambient temperature at the setup location.

13.2 Rating plate

The rating plate with the connection and performance data can be founded on the back of
the device.
Please note
and to set the temperature in the range of 5-20°C.
and for 5 seconds, the temperature display mode will be
and you can adjust the
38