ASROCK A780FullDisplayPort Mode D'emploi page 20

2. If you connect the DVI-to-HDMI converter to the VGA/DVI-D port, please connect the
HDMI monitor cable to the DVI-to-HDMI converter. If you don't connect the
DVI-to-HDMI converter to the VGA/DVI-D port, please connect the DVI-D monitor
cable to the VGA/DVI-D port. And connect the D-Sub monitor cable to the
VGA/D-Sub port.
3. Boot your system. Press <F2> to enter BIOS setup. Enter "Share Memory"
option to adjust the memory capability to [32MB], [64MB], [128MB] [256MB] or
[512MB] to enable the function of VGA/D-sub. Please make sure that the value you
select is less than the total capability of the system memory. If you do not adjust
the BIOS setup, the default value of "Share Memory", [Auto], will disable
VGA/D-Sub function when the add-on VGA card is inserted to this motherboard.
4. Install the onboard VGA driver and the add-on PCI Express VGA card driver (if you
install the PCI Express VGA card) to your system. If you have installed the drivers
already, there is no need to install them again.
5. Set up a multi-monitor display.
®
For Windows XP / XP 64-bit OS:
Right click the desktop, choose "Properties", and select the "Settings" tab so
that you can adjust the parameters of the multi-monitor according to the steps
below.
A. Click the "Identify" button to display a large number on each monitor.
B. Right-click the display icon in the Display Properties dialog that you wish
to be your primary monitor, and then select "Primary". When you use
multiple monitors with your card, one monitor will always be Primary, and
all additional monitors will be designated as Secondary.
C. Select the display icon identified by the number 2.
D. Click "Extend my Windows desktop onto this monitor".
E. Right-click the display icon and select "Attached", if necessary.
F. Set the "Screen Resolution" and "Color Quality" as appropriate for the
second monitor. Click "Apply" or "OK" to apply these new values.
G. Repeat steps C through E for the diaplay icon identified by the number
one, two, three and four.
®
For Windows Vista
Right click the desktop, choose "Personalize", and select the "Display
Settings" tab so that you can adjust the parameters of the multi-monitor
according to the steps below.
A. Click the number "2" icon.
B. Click the items "This is my main monitor" and "Extend the desktop onto
this monitor".
C. Click "OK" to save your change.
D. Repeat steps A through C for the display icon identified by the number
three and four.
2 0 2 0 2 0
2 0 2 0
ASRock
TM TM
/ Vista 64-bit OS:
A780FullDisplayPort Motherboard