Operation - 3M Graco 50261 Manuel D'instructions

WARNING
PRESSURIZED EQUIPMENT HAZARD
The system pressure must be manually relieved to prevent the
system from starting or spraying accidentally. To reduce the risk of
an injury from accidental spray from the gun, splashing fluid, or
moving parts, follow the Pressure Relief Procedure
• are instructed to relieve the pressure,
• stop spraying,
• check or service any of the system equipment,
• install or clean the spray nozzle.
Pressure Relief Procedure
1. Turn off the air supply to the gun.
2. Disconnect air line from the gun.
3. Invert gun and pull trigger (fully open, not partially) to return
mix to gun cap.
Fig. 13
Grounding
Ground all equipment and conductive objects and use only grounded
hoses and pails.

Operation

Applying the Fluid
1. To achieve the best results when applying fluid, keep the gun
perpendicular to the surface and maintain a consistent distance
of approximately 150 to 200 mm (6 to 8 inches) from the object
being sprayed. See Fig. 14.
whenever you:
2. To obtain an even finish, use smooth, even strokes across the
surface to be sprayed with 50% overlap. The PPS gun cup is a
sealed system and can be sprayed in any direction without spills
on vertical or horizontal surfaces.
3. Paint using parallel strokes. This spray gun applies all coatings
evenly without cross coating.
Fig. 14
6
WRONG
RIGHT