Kärcher KM 85/50 R Bp Mode D'emploi page 23

Dust filter (flat filter)
1
Frame
2
Hold-down plate
3
1. Shut down the device safely.
2. Clean the dust filter with the manual filter cleaner.
3. Completely open and secure the cover.
4. Remove the hold-down plate.
5. Remove the dust filter upwards.
6. As necessary: Clean the dust filter. (vacuum or carefully tap it
out) or insert a new dust filter.
Replacing / setting the sealing strips
Sealing strips Settings
Side sealing strips Distance from floor 2 - 3 mm
Front sealing strip Trailing distance 10-15 mm
Rear sealing strip Trailing distance 5-10 mm
Note
The trailing distance of the front and rear sealing strip defines
how much the sealing lip folds backwards when driving the de-
vice forwards.
When set correctly, there must be a gap between the side sealing
strips and the floor.
Fastening
1
Side sealing strip
2
Front sealing strip
3
Rear sealing strip
4
1. Unfasten the fastening of the sealing strips.
2. Set the sealing strip by shifting it in the elongated holes.
3. Refer to the table for the values.
4. Once the settings are correct, fasten the sealing strips.
Checking the main fuse
Main fuse, 125 A
1
Positive terminal connection
2
Terminal cover
3
1. Remove the terminal cover.
2. Check the main fuse.
3. If the main fuse is faulty, there are various possible causes. In
such a case, contact Customer Service.
Jack
1
Rear wheel
2
Washer
3
Screw
4
Sleeve
5
1. Unfasten the screw a little, do not completely unscrew it.
2. Lift the device with the jack at the attachment point.
3. Unscrew the screw, remove the washer from the sleeve.
4. Remove the rear wheel from the axle.
5. Put on a new rear wheel and tighten the screw, washer and
sleeve.
Beware of the feather key!
English
Fuses
Replacing the rear wheel
23