KitchenAid KCM1204 Mode D'emploi page 15

TROUBLESHOOTING
If your Coffee Maker should fail to
operate as expected, please check
the following:
1. If the display is not illuminated:
• Check to see whether the Coffee
Maker is plugged into a grounded
3 prong outlet. If it is, check the fuse
or circuit breaker on the electrical
circuit the Coffee Maker is connected
to and make sure the circuit is closed.
2. If only a portion of the water added to
the Coffee Maker actually brews:
• The Coffee Maker requires immediate
descaling. Please refer to the "Care
and cleaning" section.
3. If you hear 3 rapid tones:
• There is no water in the water tank.
The Coffee Maker will not brew. Fill
the water tank with fresh, cool water
and continue with the brewing cycle
as described in the "Brewing coffee"
section.
4. If "Er1" flashes on the display and you
hear 1 tone:
• A button may be jammed. Unplug the
Coffee Maker and press each button
several times. Plug the Coffee Maker
into a grounded 3 prong outlet. If
"Er1" appears again on the display,
repeat this procedure.
5. If coffee overflows the brew basket:
• The brew basket is not completely
closed. Close the brew basket and
ensure it clicks firmly into place.
• Too much coffee was placed in to the
brew basket.
6. If water exits from the back of the
Coffee Maker:
• Too much water was poured into the
water tank.
If the problem is not due to one of
the above items, see the "Arranging
for Service" chapter in the "Warranty
and service" section.
Do not return the Coffee Maker to the
retailer as they do not provide service.
TROUBLESHOOTING | 15