KitchenAid KCM223 Instructions page 9

4. Place the filter cartridge in the well at the
bottom of the water tank. Push the
cartridge slightly to make sure it fits
snugly.
5. Every time you install a new filter, run the
coffee maker through a complete
brewing cycle without coffee. Use a full
carafe of clean, cool water.
To Set the Time-of-Day Clock
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong
outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions
can result in death, fire, or
electrical shock.
1. Plug into a grounded 3-prong outlet.
2. When the coffee maker is first plugged
in or when power is restored after an
interruption, the brew timer display will
initially show 12:00 PM.
3. For glass carafe models, press the
MODE button 5 times to enter the
Time/Clock Setting mode.
NOTE: For thermal carafe models, press
the MODE button 4 times to enter the
Time/Clock Setting mode.
The Clock indicator will flash while the
time is being set.
4. Press the PROGRAM/SET button. The
hours digits will flash for the hours
adjustment.
5. Press the "+" (plus) or "-" (minus)
buttons to increase or decrease the
hours.
6. Press the PROGRAM/SET button again.
The minutes digits will flash for the
minutes adjustment.
7. Press the "+" (plus) or "-" (minus)
buttons to increase or decrease the
minutes.
8. Press the PROGRAM/SET button again.
The AM or PM indicator will flash for the
AM/PM adjustment.
9. Press the "+" (plus) or "-" (minus)
buttons to select AM or PM.
10. Press and hold the PROGRAM/SET
button to program the settings. A short
beep will sound indicating programming
is complete.
NOTE: If you do not hold the Program/Set
button until a short beep is heard, the
settings will be maintained and the coffee
maker will exit to the default mode.
9