Installer Final Checklist; Fuel Conversion; Lighting Instructions; Before Lighting - Jackson Grills Supreme JSS550BI-LP Manuel D'utilisation


Ensure that clearances to combustible materials are maintained per specifications listed in this manual.

Make sure that all internal packaging has been removed.

Check that the burners are sitting properly on orifice end of the valves. (Pg.7)

Check grill label to confirm that the gas configuration matches the fuel being supplied

When using natural gas, ensure the appliance pressure (between NG regulator and
main manifold) is at 4" WC with a maximum 7"WC entering the regulator.

For propane grills confirm that inlet pressure is at 11" WC; NOTE that the original
Jackson regulator and hose are preset to 11" WC.

Ensure that all the gas knobs turn freely.

Leak test grill and all gas connections.

Grill test fired, and all functions working and in good order.

User informed of gas supply shut off valve location.

Owner's manual given to grill user.
This grill is convertible to Natural Gas or Propane when needed, with the installation of the appropriate Gas
Conversion Kit. (See parts list, Pg. 22 & 23) The kit should be installed by a qualified gas fitter. Please contact your
local dealer for information.

1. BEFORE LIGHTING:

•
Always inspect the gas supply hose before turning the gas "ON". If there is evidence of cuts, wear, or
abrasion, it must be replaced before use. Use only a manufacturer approved replacement hose.
•
Check all gas connections for leaks before each use. Do not light grill if gas odor is present.
2. TO LIGHT MAIN BURNERS OF THE GRILL: (see Fig. 10)
•
Read instructions before lighting (see labels on top edge of the pull-out grease tray)
•
Open lid prior to lighting your grill.
•
Turn all knobs to "OFF" then open the propane cylinder valve, OR natural gas valve on your gas
connection. NOTE: Always keep your face and body averted when lighting.
•
Push in and rotate each control knob counter clockwise slowly, to the HI position. (When rotating the knob,
rotate for a two to four second count: do NOT turn the knob rapidly) The built-in igniter
spark, thus lighting the torch light pilot flame, then the main burner. If the burner does not light
IMMEDIATELY turn the knob to off and wait 5 minutes for gas to dispel and repeat the lighting procedure.
•
Follow match lighting instructions if burner can't be lit after repeating 3-4 times.
Installer Final Check List:

Fuel Conversion:

Grill Lighting Instructions:
Optional # JGSB Side Burner
14
will click and