FARFISA INTERCOMS ZHERO ZH1262B Mode D'emploi page 19

3.2 Programming
Installation wizard enables setting user addresses only; all the other parameters can be set proceeding as follows:
- operate the wheel to access the main menu;
- select "Settings"
indications below.
Intercommunicating
Entrances
Actuations
Unlocking Unlocking
procedure procedure
Warning, entering installing
menu you could affect
the correct operations of
the whole system
Press in sequence "One",
"Two" and "One" to
continue
Intercommunicating
Entrances
Actuations
Intercommunicating. Enter the addresses and the names
of the devices with which the videointercom should
communicate. The names can be modified at a later time by
the user by accessing the "Set-up" menu.
Entrances. Enter the addresses and the names of the
entrances to which the videointercom should connect. The
names can be modified at a later time by the user by accessing
the "Set-up" menu.
(run the unlock procedure)
Language
Audio
Back
Exit
Two
!
One
.
Installation Installation
wizard wizard
Favourite Favourite
buttons buttons
Back
access sub-menus to set the required parameters following the
Video
Settings
About
System
Default
Advanced
Actuations. Enter the addresses and the names of the
devices that can be activated by videointercom. The
names can be modified at a later time by the user by accessing
the "Set-up" menu.
Installation wizard. See section 3.1 at page 18.
Favourite keys. Select the key to be programmed and then
the function to assign.
- 19 -
Back
Show Show
settings settings
Back
Mi 2475