Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Specifications
All values given in this section are typical values.
General
output power CEA-2006 / 490A (1% THD, 1 kHz, all
channels driven)
amplification class
Digital Signal Processor (DSP)
frequency response 20 Hz - 20 kHz
distortion THD+N (20 Hz - 10 kHz)
output dynamic range (20 Hz - 20 kHz, 8 Ω, A-weighted)
amplification gain
noise level (20 Hz - 20 kHz, 8 Ω, A-weighted)
channel separation (at 1 kHz , 3 x 120 W, 4 Ω)
damping factor
output delay
mains input power and current draw (all channels driven)
maximum output power
1/3 output power (-5dB)
1/8 output power (-9 dB)
idle
standby
Current values given for mains rated at 230 V. Multiply by:
— 2.3 for 100 V
— 1.9 for 120 V
— 1.15 for 200 V
power supply
model
power factor
mains rating
nominal current requirements
operating conditions
temperature
7
4 x 1400 W RMS at 8 Ω
10.5 A / 2300 W
4.8 A / 1050 W
1 A / 160 W
0.6 A / 10 W
4 x 1400 W RMS (at 8 Ω)
4 x 2600 W RMS (at 4 Ω)
4 x 3300 W RMS (at 2.7 Ω)
Class D
2 x SHARC 32-bit, floating point, 96 kHz sampling rate
± 0.1 dB (at 8 Ω, 60 W output power)
± 0.1 dB (at 4 Ω, 120 W output power)
< 0.05% (at 8 Ω, 60 W output power)
< 0.1% (at 4 Ω, 120 W output power)
> 114 dB
32 dB
< - 72 dBV
> 85 dB
> 400 (1 kHz and below, 8 Ω)
0 ms to 1000 ms
4 x 2600 W RMS at 4 Ω
19 A / 4200 W
8.1 A / 1850 W
1 A / 160 W
0.6 A / 10 W
universal Switched Mode Power Supply (SMPS) with
power factor correction (PFC)
> 0.9 (except Standby on all voltages, and Idle on 230 V)
100 V - 240 V ~ ±10%, 50-60 Hz
30 A for 100-120 V, 16 A for 200-240 V
room temperature (from 0º C / 32º F to +50º C / 122º F)
Specifications
4 x 3300 W RMS at 2.7 Ω
26 A / 5500 W
11.5 A / 2400 W
1 A / 160 W
0.6 A / 10 W
LA12X product information version 1.0
Publicité
Table des Matières
