Safety Notes - Batavia BT-PSG001 Mode D'emploi

GB

Safety Notes

Caution! Observe the following basic safety precautions when using electric tools in order to pro-
!
tect yourself against electric shock, danger of injury and fire. Read and observe these rules before
using the unit. Keep the safety instructions in a safe place.
1. Consider environmental influences
Do not expose electric tools to rain. Do not use electric tools in humid or wet environment. Provide
good lighting. Do not use electric tools near flammable liquids or gases.
2. Protect yourself against electric shock
Avoid contact with earthed objects such as pipes, radiators, stoves, refrigerators.
3. Keep your tools in a safe place
Unused tools should be kept in a dry, locked room out of the reach of children.
4. Do not misuse the cable
Do not carry the tools by the cable and do not use it to remove the plug from the socket. Protect the
cable against heat, oil and sharp edges.
5. Maintain your tools with care
Keep your tools clean to ensure good and safe operation. Follow the maintenance instructions. Check
plug and cable regularly. If defective, have them replaced by a service station or by an authorized
dealer. Check the extension cable regularly and replace it , if defective. Make sure the extension cable
is equipped with the prescribed earthing contact. Keep the handles dry and free from oil and grease.
6. Remove the mains plug
Remove the mains plug when the unit is out of use, before maintenance work and when mounting
accessories.
7. Avoid unintentional start
Do not carry tools which are connected to the mains with your finger on the switch. Make sure that
the switch is off when connecting the unit to the mains.
8. Outdoor extension cable
When working outdoors only use approved and respectively marked extension cables.
•
Please read the operating instructions thoroughly and observe the safety instructions
•
Only coating materials such as paints, enamels, varnishes, etc, with a flash point of 21°C(32°C in the
United Kingdom) hand above may be sprayed, without additional warming. In Germany these are
coating materials in the danger classes AⅡand AⅢ, see paint tin.
•
The device may not be based in work places which are covered by the explosion protection regulations.
•
When spraying, ensure that there are no sources of ignition, e.g. open fire, cigarettes, cigars, and
pipes, sparks, glowing wires, hot surfaces, etc, in the area.
Recommendation wear breathing protection when spraying. Caution, danger of injury!
!
Never point the spray gun at yourself or other persons or animals.
•
When working with the device inside and outside care must be taken that no solvent vapors are
sucked into the device.
•
When working outdoors observe wind direction. When working indoors ensure that there is suffi-
cient ventilation.
•
Do not spray at the device.
•
The device only splash-proof when the air hose is correctly connected.
•
Do not let children play with the device. Keep out of reach of children.
•
Care must be taken that the mains cable is not damaged. If damage is observed take it immediately
to an authorized customer service centre to be changed.
•
Remove mains plug from socket when not in use.
10
|