Cleaning
B
A
Position the appliance so that the
1.
GB
boiler safety cap is uppermost.
Remove the rubber cover, unscrew
the boiler safety cap using the flat
key enclosed in the bottom. Turn
the appliance upside-down over
a sink and completely empty the
boiler.
4.
Pour out the mixture. Fill the boiler
with clean water, then pour it out.
Repeat this step for several times
until the scales are removed and
there is no longer a descaler smell.
Place back one measuring cup of
clean water in the boiler before
reassembling.
THE WARRANTY DOES NOT
COVER DAMAGE CAUSED BY
CLOGGING DUE TO LIME.
Once cleaning is done, do not keep
the boiler completely empty but
leave some water still there (before
closing it again).
26
DBS7135_Safirina_SteamStation_BASE_AEG.indd 26
Mix a descaler agent and water
2.
at the specified ratio, prepare at
least 300ml descaler mixture. (Use
recommended ratio for the mixture,
if there is much scaling, properly
increase the proportion of descaler.)
Note: We recommend to use the
descaler ECF5 from AEG. Please
follow the water/ descaler liquid
ratio instructions on the bottle. We
recommend to clean the product
every 2 months.
When finished using the
5.
appliance, turn the temperature
dial to the OFF ("MIN") position.
Store the iron on the iron rest.
Note: Do not store the iron with
water in the tank.
A
B
Fill the mixture into the boiler
3.
and tighten the boiler safety cap.
Soak for one to two hours under
room temperature (increase the
soaking time if necessary; max 8
hours).
2015-05-25 10:18:25