▶
Auto OverClock Technology
Settng ths tem to [Max FSB] allows the system to detect the FSB lmtaton for over-
clockng automatcally. If overclockng fals, you can try the lower FSB clock for over-
clockng successfully.
▶
MultStep OC Booster
Ths tem s used to avod the BIOS mght crash wth overclockng.
[Dsabled]
Dsable ths tem, apply OC settngs durng POST.
[Mode 1]
Slght OC durng POST and then apply full OC when loadng the
OS
[Mode 2]
Load the OS then apply the OC settngs.
▶
Memory-Z
Press <Enter> to enter the sub-menu.
▶
DIMM1~4 Memory SPD Informaton
Press <Enter> to enter the sub-menu. Ths sub-menu dsplays the nformaton of
nstalled memory.
▶
Advance DRAM Configuraton
Press <Enter> to enter the sub-menu.
▶
DRAM Tmng Mode
Ths field has the capacty to automatcally detect all of the DRAM tmng. If you set
ths field to [DCT 0], [DCT 1] or [Both], some fields wll appear and selectable. DCT
0 controls channel A and DCT1 controls channel B.
▶
DRAM Drve Strength
Ths tem allows you to control the memory data bus' sgnal strength. Increasng the
drve strength of the memory bus can ncrease stablty durng overclockng.
▶
DRAM Advance Control
Ths field has the capacty to automatcally detect the advanced DRAM tmng. If you
set ths field to [DCT 0], [DCT 1] or [Both], some fields wll appear and selectable.
▶
1T/2T Memory Tmng
Ths tem controls the SDRAM command rate. Select [1T] makes SDRAM sgnal
controller to run at 1T (T=clock cycles) rate. Selectng [2T] makes SDRAM sgnal
controller run at 2T rate.
▶
DCT Unganged Mode
Ths feature s used to Integrate two 64-bt DCTs nto a 128-bt nterface.
▶
Bank Interleavng
Bank Interleavng s an mportant parameter for mprovng overclockng capablty of
memory. It allows system to access multple banks smultaneously.
Englsh
En-33