Troubleshooting - BOMANN DU 7603 G Mode D'emploi

Replacing the bulb
CAUTION:
Do NOT remove the LED lighting cover!
The bulb may only be replaced by an authorized
specialist in case of a defect.
WARNING:
 The LED light is very bright and can damage the
eyes. Never look directly into the LED light!
 Disconnect the appliance from the power supply
and allow the lamps to cool down before changing
the lamp. There is a risk of burns!
NOTE:
Order the lamps from your dealer or in our online
accessories shop www.bomann-germany.de.
Lamp data: LED max. 2 x 1.5 W, DC 12 V,
ILCOS D Code acc. EN 61231: DSR-1.5/30-S-64
 Remove the grease filter(s). Carefully push the
lamp out of the holder through the housing; pull
out the lamp and release the plug connection.
 Replace defect LED module and connect the two
ends of the plug-in device.
 Insert new lamp properly in the bulb holder. Re-
place the grease filter(s).
Light stripes (ambient lighting)
Lamp data: LED max. 2 x 6.0 W, DC 12 V,
Length 275 mm
 Open the protective box below the glass cover
and loosen the light strip holder with a screwdriv-
er. Release the plug connection.
 Replace defect LED module and pin the two ends
of the plug-in device.
 Insert new light strip properly in the stripe holder.
Close the protective box with inserted plug con-
nection and secure the light strip holder.

Troubleshooting

Before you contact an authorized specialist
Problem Possible Cause / Solution
Unit is not
- Check the power supply.
working or
- Check the power level.
not properly
Unit is not
- Check the power level.
working
- Is the kitchen properly ventilat-
efficiently
- Clean the grease filter(s).
- At recirculation mode, check the
- Check the air outlet.
Light is not
- Check the bulb, see
working
Oil is drip-
- Clean the grease filter(s).
ping
NOTE:
If you are still having problems after following steps
above, contact your trader or an authorized techni-
cian.
48
ed?
carbon filter.
"Replacing
the bulb".