Environmental Concerns - Zanussi ZFU422W Notice D'utilisation

To change the opening direction of the door, do these
steps:
1. Remove the plinth.
2. Unscrew and remove the lower hinges.
3. Remove the door.
A
B
7. Unscrew the pin (A) and screw it on the opposite side.
8. Remove the cap (B) and position it on the opposite
side.
9. Screw the lower hinges.
10. Refit the plinth.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Winter), the gas-
ket may not fit perfectly to the cabinet. In that case, wait
for the natural fitting of the gasket.

Environmental concerns

The symbol on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it should be taken to the
appropriate collection point for the recycling of electrical
and electronic equipment. By ensuring this product is
20
• Remove the plug from the power socket.
• Tilt back the appliance carefully so that the compressor
cannot touch the floor.
4. Unscrew the upper pin and screw it on the opposite
side.
5. Refit the door.
6. Make sure the edge of the door is parallel with the edge
of the top.
11. Stand the appliance upright.
12. Fit the handle on the opposite side and put the plastic
caps (contained in the instructions bag) in the free holes.
In case you do not want to carry out the above mentioned
operations, contact the nearest After Sales Service Force.
The After Sales Service specialist will carry out the rever-
sibility of the doors at your cost.
disposed of correctly, you will help prevent potential
negative consequences for the environment and human
health, which could otherwise be caused by inappropriate
waste handling of this product. For more detailed
information about recycling of this product, please contact