Introduction To The Recovery Unit Easyrec120R100; Standard Equipment And Components Description; Recovery Compressor; Filter - wigam EASYREC 120R100 Manuel D'utilisation

EASYREC120
1.

Introduction to the recovery unit EASYREC120R100

Considering its reduced volume and the extreme facility of transportation, the unit is suited for
interventions on civil conditioners, automotive vehicle conditioners, dispensers, domestic and
commercial refrigerators and dehumidifiers.
The unit is supplied with an oil-less compressor without lubricant.
2.

Standard equipment and components description

2.1. R
ECOVERY COMPRESSOR
Unit EASYREC120R100 is equipped with an oil-less compressor and is suitable for any type of CFC,
HCFC and HFC refrigerant.
2.2. F
ILTER
The filter is equipped with two 1/4sae male connections. It is supplied with a hose to make the
connection easier. The unit is also equipped with a moisture indicator that allows to check the quality of
the filter.
2.3. M
OISTURE INDICATOR
The moisture indicator must be connected between the filter and the recovery unit. It allows to check the
quality of the filter. Replace the filter whenever the indicator shows that there is moisture.
2.4. P
RESSURE GAUGES
Unit EASYREC120R100 is equipped with two oil-filled pressure gauges Ø60mm: one pressure gauge on
the suction line and one on the discharge line. They allow to check the pressure during recovery and
refrigerant transfer with the push-pull method.
2.5. D
ISTILLATION SYSTEM
Unit EASYREC120R100 is provided with a distillation system (that can be excluded): it is equipped with
an automatic device for flow regulation and allows the complete separation of the oil (coming from the
system) from the refrigerant.
This equipment must NOT work for more than 10 minutes in vacuum (-0.02Mpa) when the BY-PASS
WIGAM
USER'S MANUAL
WARNING
switch" is on the MANUAL position
ENGLISH
27