Erreka CICLON Manuel De L'installateur page 50

INSTALLATION
Position the mechanical opening and closing stopper
Option B: Operator with articulated arm
Attach the arm to the gate
46
Installation manual
1 Attach the in-ground stop in opening (1) to the
support plate (2) with the nut (3)-screw set (4).
2 Attach the in-ground central stop (in the opposite
direction to the opening stopper) to the support
plate with the screw-nut set.
1 In model CLS210F, unlock the motor with the
unlocking key, see section "Manual operation" on
page 37.
2 Close the gate, extend the arm (1) to a maximum of
670 mm and mark the positions (A) and (B) of the
attachment bracket orifices (2).

Ensure the indicated distance is not exceeded,
see "Fig. 5 Example of assembly position for
operator with articulated arm".
3 Make the orifices in the gate in the position marked.
4 Attach the support (2) to the gate.

See the articulated arm instructions.