Erreka CICLON Manuel De L'installateur page 49

Attach the arm to the operator
Option A: Operator with articulated arm
Attach the arm to the gate
1 Remove the plastic cover (3) by releasing the screw
(1) and the nut (2).
2 Position the arm (4).
3 Replace the plastic cover (3).
4 Attach the arm (4) and the top (3) to the operator (1)
and the nut (2).
1 In model CLS210F, unlock the motor with the
unlocking key, see section "Manual operation" on
page 37.
2 Close the gate and mark the arm bearing position
on the gate (A).
3 Open the gate to the required point and mark the
arm bearing position on the gate (B).
4 Attach the rail (1) to the gate (2), aligned with
regards to the two marks made.

See the sliding arm instructions.
CICLÓN Electromechanical Operator
INSTALLATION
45