Quick Start; Listening To The Demo Performances; Connecting And Playing Instruments - Korg STAGEMAN 80 Manuel D'utilisation

Quick Start

This quick start section explains the basic functionality of the
STAGEMAN 80. Start by reading this chapter to understand
the basic functions; then read the subsequent chapters to
delve in deeper.
Listening to the demo
performances
The STAGEMAN 80 contains demo song data. Let's start by
listening to the sound of the STAGEMAN 80.
4
1
1
1. Simultaneously press the [SYSTEM] button and [Count
Start] button to enter Demo mode.
The [SYSTEM] button and [Count Start] button blink, and
the demo song plays.
The top panel buttons light in synchronization with the
demo song.
2. Use the VOLUME knob to adjust the volume of the
demo song.
3. You can press the [ ] or [
previous or next demo song.
4. To exit Demo mode, press any one of the mode buttons
[RHYTHM], [RECORDER], [PLAYER], or [SYSTEM].
2
3
] buttons to play the
Connecting and playing
instruments
The STAGEMAN 80 provides a mic input, two inputs for guitar
or bass, and an AUX input, allowing multi-channel mixing. A
variety of input sources are supported, including guitar, bass
guitar, and a microphone.
Playing guitar
Here's how to connect a guitar.
1
1,2
1. Set the (INPUT) 1 knob and the VOLUME knob to
the minimum position, and connect your guitar to the
INPUT 1 jack.
2. Use the (INPUT) 1 knob to adjust the input level.
To avoid signal clipping (signal that's too loud) this knob
should be adjusted so that the peak LED doesn't light up
when signal is being loudly input.
3. While playing your guitar, use the VOLUME knob to
adjust the volume that is output from the speakers.
4. Use the TREBLE knob and BASS knob to adjust the
tone.
5. As necessary, use the REVERB knob to adjust the effect.
You can apply a reverb effect to the signals from the MIC
IN jack, INPUT 1 jack, and INPUT 2 jack.
Tip: If you're using a VOX VFS5 foot switch, you can use
it to turn reverb on/off.
6. If you enable the Acoustage function by pressing the
[ACOUSTAGE] button, the audio output from the
STAGEMAN 80 will be heard in an expansive stereo
field.
When the Acoustage function is enabled the wide stereo
effect will be applied to all audio signals output from the
STAGEMAN 80.
Quick Start
6
4
1,3
5
13