Installer Setting - Ceiling Height Selection - LG PREMTB10U Manuel D'installation Et D'utilisation

INSTALLATION INSTRUCTIONS
72

Installer Setting - Ceiling Height Selection

This function is to adjust FAN Airflow rate according to ceiling height (For ceiling type product)
<Ceiling Height Selection Table>
Ceiling Height Level
01 Low
02 Medium
03 High
04 Very high
• Ceiling height setting is only available for some products.
• Ceiling height of 'Very high' function may not exist depending on the indoor unit.
• Refer to the product manual for more details.
1 Press the
to enter Thermostat installer setup
mode.
- If pressed for a shorter time, it
enters into user setup mode.
If moving to ceiling height selection menu
2
through
below.
3 Select ceiling height value by pressing
03:High, 04:Very high)
Function Code
Press
4
Press
5
After setup, it automatically exits after 25
seconds if there is no input. If the
Setting/Cancel button is not pressed, the
mode will not change.
Decrease the indoor airflow rate 1 step from standard level
Set the indoor airflow rate as standard level
Increase indoor airflow rate 1 step from standard level
Increase indoor airflow rate 2 steps from standard level
button for 3 seconds
button, it indicates as pictured
buttons. (01:Low, 02:Medium,
ceiling height setting
button to save.
button to exit settings mode.
Description