Connecting The Drain Line; Connect To The Power Supply - KENMORE ELITE 796.2927 Guide D'utilisation Et D'entretien

CONNECTING DRAIN LINE
• The drain hose should always be properly secured.
Failure to properly secure the drain hose can result in
flooding and property damage.
• The drain must be installed in accordance with any
applicable local codes and regulations.
• Make sure that the drain hose is not stretched, pinched,
crushed, or kinked.
Option 1: Standpipe
NOTE:
• Total height of the hose end should be approximately
35"~47" (0.9~1.2 m) from the floor.
• The drain hose should be inserted no more than 4 inches
into the standpipe.
• Do not install the end of the drain hose higher than 96 in.
(243.8 cm) above the bottom of the washer.
INSTALLATION INSTRUCTIONS
Firmly insert the free end of the drain hose into the drain
opening of your home. Make sure the soft rubber end is
completely inside the drain opening.
• If the water valves and drain are built into the wall, fasten
the drain hose to one of the water hoses with the cable
tie (ribbed side on inside).
• If your drain is a standpipe, fasten the drain hose to the
standpipe with the cable tie provided.
Drain Line
Stand Pipe
35"~47"
(0.9~1.2 m)
Washer should be plugged into a 120-VAC, 60-Hz
grounded 3-prong outlet. Plug in the washer.
10
35"~47"
(0.9~1.2 m)
Cable Tie

CONNECT TO THE POWER SUPPLY

WARNING
Improper connection of the equipment-grounding
conductor can result in risk of electric shock. Check
with a qualified electrician or serviceman if you are in
doubt as to whether the appliance is properly
grounded. Do not modify the plug provided with the
appliance. If it does not fit the outlet, have a proper
outlet installed by a qualified electrician. Failure to
follow these warnings can cause serious injury, fire,
electrical shock, or death.
35"~47"
(0.9~1.2 m)
Cable Tie