Dolmar RM-72.13 H Manuel D'utilisation page 63

EN 16
For hydrostatic drive models:
21. B
RAKE PEDAL
In hydrostatically driven models
this pedal is solely for braking
and works on the rear wheels.
22. S
PEED CHANGE LEVER
This lever engages drive to the
wheels and changes the
machine's forward and reverse
speed.
The machine's forward speed
gradually increases by moving
the lever towards «F». Reverse
is engaged by moving the lever to
«R».
When the brake pedal (21) is
pressed the lever automatically
returns to the «N» (neutral) position. It can also be
moved there manually even without pressing the
brake.
IMPORTANT
engaged the speed change lever is locked in the «N» position and cannot be
moved until the parking brake and the pedal have been released.
23. L
EVER TO RELEASE THE HYDROSTATIC DRIVE
This lever has two positions shown on the plate:
Position «A» = Drive engaged: for all operating conditions, when moving and
Position «B» = Drive released: considerably reduces the effort required for
IMPORTANT
must be carried out only when the engine has stopped with the lever (22) at
position "N".
To avoid damaging the transmission unit, DO NOT START the engine with
the release lever in position "B".
When the parking brake (3) is
during cutting;
moving the machine manually, when the engine is not run-
ning.
To avoid damaging the transmission unit, this operation
COMMANDS AND CONTROL INSTRUMENTS
21
22
N
R
A
23
F
B