Display In The Operating Display/ Setting; Operation Mode / Pulse - Ecolab Elados EMP III E60 Mode D'emploi

10.2.2.2 Display in the operating display/ Setting

The metering rate can be configured/adjusted in the operating display during operations.
If the newly set value is not confirmed within 10 seconds by pressing the START/STOP
NOTE
key, the system reverts to the primarily value.
Fig. 10.4 Display inthe operating display / Setting: Strokes
Fig. 10.6 Display inthe operating display / Setting: Liter
10.2.3

Operation mode / pulse

For the "pulse" operation mode, the metering pump only works in conjunction with incoming
pulses (e.g. from a contact water meter).
The following pulse processing options can be selected:
•
Multiplication
•
Division
417101441_EMP_III_E60.docx
Strokes/min
Liter
Incoming pulses are multiplied by a configurable factor (n):
1 pulse = n pump strokes (default setting)
Incoming pulses are divided by a configurable factor (n):
n pulse = 1 pump stroke
Percent (%)
Fig. 10.5 Display inthe operating display / Setting: Percent
Fig. 10.7 Display inthe operating display / Setting: Gallons
- 101 -
Gallons
Rev. 13-10.19