Upgrading The Software; Setting The Function Help - Samsung HL-T7288W Manuel Du Propriétaire

Upgrading the Software

Samsung may offer upgrades for your TV's firmware in the future. Please contact the Samsung call center at
1-800-SAMSUNG to receive information about downloading upgrades and using the USB device. Upgrades will be possible
by connecting a USB drive to the USB port located on the side of your TV.
1 Insert a USB drive containing the firmware upgrade into the USB Upgrade Port on the
side of the TV.
2 Press the MENU button.
Press the ▲ or ▼ button to select Setup, then press the ENTER button.
Press the ▲ or ▼ button to select SW Upgrade, then press the ENTER button.
The message Scanning for USB... It may take up to 30 seconds. is displayed.
3 If the firmware on the USB is properly recognized, the message Upgrade version
xxxx to version xxxx? The system would be reset after upgrade. is displayed.
Press the ◄ or ► button to select OK, then press the ENTER button. The upgrade
starts.
Please be careful not to disconnect the power or remove the USB drive while
upgrades are being applied.
The TV will shut off and turn on automatically after completing the firmware upgrade.
Please check the firmware version after the upgrades are complete.
➢
When software is upgraded, video and audio settings you have made will return
to their default (factory) settings. We recommend you write down your settings so
that you can easily reset them after the upgrade.

Setting the Function Help

Displays help on the menu functions.
1 Press the MENU button.
Press the ▲ or ▼ button to select Setup, then press the ENTER button.
Press the ▲ or ▼ button to select Function Help, then press the ENTER button.
2 Press the ▲ or ▼ button to select Off or On, then press the ENTER button.
Press the EXIT button to exit.
➢ The Function Help default setting is On.
English - 62
Bluetooth
Anynet+ (HDMI-CEC)
SW Upgrade
Function Help : On
Software Upgrade
Scanning for USB.....
It may take up to 30 seconds.
Software Upgrade
Upgrade version XXXX to version XXXX ? The
system would be reset after upgrade.
OK Cancel
Anynet+ (HDMI-CEC)
SW Upgrade
Function Help : On
Anynet+ (HDMI-CEC)
SW Upgrade
Function Help : On
Off
On
▶
▶
▶