Bartscher TS 210 Mode D'emploi page 8

ASSEMBLY
1. Unpack the unit's parts and ensure all of them are present.
Remove all packing material.
2. Start assembly of the trolley by fixing the shelf to
the frame and the clearing tray.
Screw in the shelves and clearing tray using the
included Allen key, beginning with the washers
and nuts.
3. Turn the trolley upside-down and screw the
swivel castors into the frame. Place the
bumpers above the castors.
4. Carefully place the trolley on the ground and ensure all the castors are touching
the floor. Turn the screws tightly with the Allen key. Use the wrench included to
turn the nuts tightly.
5. The height of the wheels can be regulated as needed using the hex nuts.
NOTE!
Remove the protective film after assembly!
Bartscher GmbH
Franz-Kleine-Str. 28
D-33154 Salzkotten
Germany
- 4 -
Screw
phone: +49 (0) 5258 971-0
fax: +49 (0) 5258 971-120
Nut
Washer