Urmet alpha 1168/45 Notice D'installation page 11

can be used for subsequent modifications
(addition of new user keys, deletion of lost
keys, etc.).
Present any key to be transformed into a
MASTER key close to the front panel: one of
the three bars will move up to indicate that
the key has been stored as MASTER and the
buzzer will emit a continuous beep.
To assure maximum reading efficiency, the
keys must be presented to the reader with the
side with the Urmet logo or the numeric code
parallel to the front panel.
To check whether a certain key has been stored
as MASTER, move it towards the front panel:
the matching bar (already in the top position)
will flash and the buzzer will emit three beeps.
To return to normal functioning, move a MASTER
key to the front panel for approximately 7
seconds. After this time, the display will show
for some seconds:
to indicate that all the MASTER keys have been
stored; the flashing dot will then be displayed
(only if the display is enabled by means of dip-
switch 2).
PROGRAMMING
To access programming, move a MASTER key
close to the front panel.
The display will show several screen pages in
sequence. Remove the key from the front panel
when the screen page you wish to access is shown
on the display:
Current software version
(display only)
↓
User key storage/checking
↓
User key deletion/replacement
↓
Set door release time
If, by mistake, you remove the MASTER key at the
wrong time and you enter a sub-menu different from
DS1168-008A
that set, simply present the MASTER key to the
front panel briefly to restore normal functioning.
In any case, if no operation is performed for 20
seconds after accessing programming, the device
automatically returns to normal functioning.
When returning to normal functioning from the
programming phase, the following caption may
appear on the display for few seconds
(abbreviation of 'Store') this can be considered
normal and indicates that the device is permanently
storing the information received. Wait for few
seconds: the caption will disappear and the device
will return to normal functioning.
The individual sub-menus are illustrated below.
STORE USER KEY
Move the key to be stored towards the front panel.
The buzzer will emit a continuous beep and the
display will show the 'number of the key' (i.e. the
position of the key in the memory). To facilitate
management, it is advisable to apply an adhesive
label to the key and to write the 'key number' on
this.
To check that the key has been effectively stored,
move the key towards the front panel: the buzzer
will emit 3 beeps (instead of one) and the display
will show the 'number of the key'.
Repeat as explained above for all user keys to be
stored.
To return to normal functioning, rest a MASTER key
on the front panel.
USER KEY DELETION/
REPLACEMENT
To delete a user key that has been lost, you MUST
know the 'number of the key' lost.
Present the MASTER key and hold it in place for at
least 2 seconds. The following appear in alternating
manner on the LED display:
Screen 1 can be used to delete keys from 1000 to
1 2
and
11