Fixing; Electrical Connections - Dometic PI7093 Notice D'utilisation Et D'installation

IT
EN
3. INSTALLATION
3.3

Fixing

WARNING
Make sure to perfectly centre the appliance in the installation hole: it must not lie
on the walls.
The appliance is supplied with 4 fixing elements. Position the appliance inside the installation hole and insert
the 4 fixing elements (fig. 4 page 37). Tighten the screws taking care not to overtighten them.
3.4

Electrical connections

WARNING
Before proceeding make sure the appliance is disconnected from the mains power
supply.
The electrical specifications of the appliance are shown below:
Rated voltage
220-240V~ 50/60Hz
WARNING
For the direct connection to the mains power supply, a device must be fitted to
assure disconnection from the mains power supply, with a contact aperture that
allows complete disconnection in the conditions of overvoltage category III, in
compliance with installation regulations.
If a socket is used to connect the appliance to the mains power supply, the plug must
be accessible after installation.
The power cable must be positioned in such a way that no part of it reaches 75°C
above room temperature.
Always disconnect the mains power supply before working on the appliance.
WARNING
If the power cable (H05RR-F 3x2.5 mm
it replaced by the manufacturer, the technical service centre or by a person with
similar qualifications.
16
Rated power
2400 W
) is damaged, for reasons of safety have
2