Yamaha WaveRunner SUV SV1200 Manuel D'entretien page 318

– +
ELEC
INDICATION SYSTEM
Checking steps:
Connect the battery terminals to the
white four-pin connector as shown.
NOTE:
If the multi-function meter has been
removed from the water vehicle, supply
7 - 12 V to the connector (+: red, –: black)
with a remote battery or an AC adapter.
Disconnect the blue one-pin connec-
tor 1 and make sure the "WARNING"
lamp 2 lights.
NOTE:
If the "WARNING" lamp does not light,
disconnect the battery and then recon-
nect it.
Press the "A/SET" 3 and "C" 5 but-
tons at the same time. While still
pressing the two buttons, press the
"MODE" button 6 and hold all three
for more than 3 seconds. The self-indi-
cating function will then activate.
NOTE:
If the "
nect and then disconnect the blue one-
pin connector.
Sequential output (1 minute/cycle)
1 Display begins operation
2 "
3 All LCD readouts turn on
4 "
5 " " is displayed
6 " " is displayed
7 "
8 "
9 "
10 " " is displayed
11 "
12 "
13 "
14 " " is displayed
Press either button 3, 4, 5, or 6. The
self-indicating function will then stop
and the "WARNING" lamp 2 will light.
Reconnect the blue one-pin connector.
The "WARNING" lamp 2 will turn off.
7-23
" message displays, recon-
" is displayed
" is displayed
" is displayed
" is displayed
" is displayed
" is displayed
" is displayed
E
"