GOLDONI IDEA Série Mode D'emploi Et Entretien page 91

Pay special care and attention when working on the battery: the
electrolyte is corrosive and the gas released is highly flammable.
- Clogging gauge of the engine air filter
Check that the clogging gauge of the engine air filter is in the correct position
and, if it is serviced, make sure that it is correctly assembled and protected
against the outdoor weather conditions as indicated in fig. 22.
It is essential for the cable connecting to the electrical system of the machine N°
1 fig. 22 to come out of the lower part of the actual gauge itself. The engine air
intake circuit could be seriously damaged if the protection is installed in the
wrong position.
- Fuse for models 20 - 26 - 30 - 746 - 846 - 946
Before changing a fuse, find and eliminate the cause that made it blow.
Fuse protect the following circuits fig.16 (n.12 fig.2):
A = Front left parking lights, rear right, 7-pin socket, work floodlight. 10A
B = Cab power supply (+30). 15A
C = Cab power supply (+15). 10A
D = Front right parking lights, rear left, 7-pin socket, licence plate, analog
instrument lighting. 10A
E = Horn. 15A
F = Indicator lights, engine stop solenoid, alternator energising. 7.5A
G = Left low beam headlights. 7.5A
H = Hazard light power supply (+15). 10A
I = Power supply for clutch line, draught control central unit, front and rear
PTO, lift button. 10A
L = Right low beam headlight. 7.5A
M = High beam headlights. 10A
N = Stop switch. 10A
The tractor is equipped with a main 60A strip fuse located inside the fixed hood
(3 fig.13). This fuse protects the entire electric system.
91