Controlled Position; Controlled Draft - GOLDONI IDEA Série Mode D'emploi Et Entretien

Regulating lift raising and lowering speed:
The flowrate regulator n.31 fig.1 can be used to regulate lift raising and lowering
rate.
• Turn the knob clockwise to slow down lift raise and lower rate.
• Turn the knob anticlockwise to increase lift raise and lower rate.

4.9.2 Controlled position

This mode is ideal for jobs that require a constant implement position both in
and out of the ground (drill, dozer, trailed manure spreader, swather, rear offset
mower, etc.).
Controls:
- P Sets implement at the required height.
Lower lever A to position 1, turn potentiometer P until the implement reaches
the desired position. If you turn it towards the minus sign (-), the implement
lowers; towards the plus sign (+), and the implement will raise. After setting
the position. operate the lift with lever A. When the implement lowers, it will
be positioned at the height set previously.
- S Completely turned towards the minus (-) sign.
- A:
Position 0 - Lever in its middle position. The lift is in its neutral position. The
implement stays at theposition it was in.
Position 1 . Lever forward The implement lowers to reach the set height.
Position 2 - Lever back. The implement raises as long as the lever is pulled
back. When themaximum height has been reached, the limit switch stops the
lift. When released, the lever will automatically reset to its neutral position 0.

4.9.3 Controlled draft

(only for controlled draft lifts)
This is ideal for jobs that require constant draft effort as it avoids engine
overloading and reduces slipping (reversible and disk ploughs, every type of
cultivator, etc.).
Controls:
- P Completely turned to the minus (-) sign.
- S Sets the working depth for the pull force need to bring and keep the tractor to
the limit of its slip point.
Lower lever A to position 1 and turn potentiometer S until the implement
reaches the desired position but always within the tractor's non-slip
performance level.
Turn towards the plus (+) sign and the draft decreases by limiting working
depth; turn towards the minus (-) sign draft increases as working depth is
greater. After regulating draft, operate the lift using lever A. When the
implement is lowered, it will be positioned for the draft set.
- A:
Position 0 - Lever in its middle position. The lift is in its neutral position. The
implement will remain in its actual position.
84