Transport; Storage; Possible Faults - ATIKA BH 1400 N Notice Originale

 Force some grease into the zerk fitting.

Do not fully fill the gearbox. Grease expands due to
heat generated during operation There is the risk of damag-
es to seals and grease leakage when the gearbox is fully
filled with grease.
Use SHELL Albida Grease EP 2, for example, or an equiva-
lent grease brand.
 Check the sealing rings (24) for damages and replace
them if required.
 Re-install the drain plugs and the hoeing tools.
Cleaning
Clean the machine thouroughly after each application so

that the faultless function is kept.
Risk of injury! Wear protective gloves when
working on the hoeing tools.
 Remove the dirt with a cloth or brush.
 Clean the device immediately after finishing the work.
 Clean the underside of the device and the hoeing tools.
 Clean the housing, especially the vent slots, from dirt stuck
to it. Do not clean the machine with running water or high-
pressure cleaners.
 Do not use solvents (gasoline, alcohol, etc.) for plastic parts,
otherwise such parts may be damaged.
Before each fault elimination:
 Switch off device.
 wait until the hoeing tools are stationary
 Pull out mains plug.

After each fault clearance, put into operation and recheck all security installations.
Fault code
Trimmer does not operate.
Trimmer does not operate.
20

Possible faults

Possible cause
 No power
 Extension cable defective.
 Main plug, motor or switch defect
 Protective motor switch has tripped

Transport

Before each transport
 Switch off device.
 wait until the hoeing tools are stationary
 Pull out mains plug.
The hoeing tools can be damaged during transport, e.g.
on hard ground, even when the motor is switched off.
Before transporting, turn therefore the wheels down-

wards to the transport position or carry the device on the
handle.

Storage

Pull out mains plug.
 Store unused equipment in a dry, locked place out of the
reach of children.
 In case of extended storage (e.g. during winter) ensure that
the device is protected against frost and corrosion.
 Before a longer period of storage carry out the following to
extend the machine's service life and ensure an easy oper-
ating:
 Thoroughly clean the device.
 Treat metal parts after each use against corrosion using
an environmentally friendly biologically degradable spray
oil.

To store the device space-saving it is possible to
fold down the upper handle hoop (1). For this, loosen the
thumb nut (21) until you can fold down the handle hoop.
Corrective action
 Check power supply, power outlet, fuse protec-
tion
 Check extension cable, exchange defect cable
immediately
 Have main plug, motor or switch checked by an
approved electrician or replaced by original
spare parts
1. Excessive working depth  reduce the working
depth
2. Hoeing tools blocked  remove the blockage
Allow the motor to cool down approx. 15 minutes
before continuing to work