Description Of Device / Spare Parts; Assembly - ATIKA BH 1400 N Notice Originale


Protect yourself against electric shocks. Avoid body contact
with grounded parts (e.g. pipes, heating apparatus, cookers,
fridges etc.)
 This device generates an electromagnetic field during oper-
ation. Such a field may affect active or passive medical im-
plants under certain circumstances. To reduce the risk of
serious injuries we recommend persons who carry medical
implants to consult their doctor and the manufacturer of the
medical implant before operating this device.
 Regularly check the extension cables and replace them if
they are damaged.
 Do never connect a damaged cable to the mains. Do not
touch a damaged cable before it is disconnected from the
mains. A damaged cable may cause contact with live parts.
 Do not use any defective connection cables.
 When working outdoors, only use extension cables espe-
cially approved and appropriately labelled for outdoor use.
 Do not set up any provisional electrical connections.
 Never bypass protective devices or deactivate them.
 Only hook up the machine by means of a fault-current circuit
breaker (30 mA).
The electrical connection or repairs to electrical parts of
the machine must be carried out by a certified electrician
or one of our customer service points. Local regulations –
especially regarding protective measures – must be ob-
served.
Repairs to other parts of the machine must be carried out
by the manufacturer or one of his customer service points.
Use only original spare parts, accessories and special
accessory parts. Accidents can arise for the user through
the use of other spare parts. The manufacturer is not lia-
ble for any damage or injury resulting from such action.

Description of device / spare parts

 Please refer to the attached assembly and operating
instruction sheet.
Pos. Designation:
1 Upper handle hoop
2 Switch handle
3 Mains plug
4 Cable strain relief
5 Cable clip
6 Lower handle hoop
7 Motor housing
8 Accessories bag
9 Safety label
10 Handle hoop holder
11 Protective cover
12A Hoeing tool (double) – RH
12b Hoeing tool (single) – RH
13A Hoeing tool (double) – LH
13b Hoeing tool (single) – LH
14 Transport wheel
15 Hoeing spur
16 Control cable
17 Power cable
18 Circlip
19 Frame for transport wheels
20 Hub cap
21 Thumb nut
22
Locking knob 
23
Drain plug 
24
Sealing ring 
Handle hoop
Secure the lower handle hoop (6) on the hoop holders (10)
on the motor housing. Use the supplied fasteners (2x
screw M6x45, 2x wing nut M6).
Fasten the upper handle hoop (1). Use the supplied
fasteners (2x screw M6x45, 2x wing nut M6).
Attach the cable strain relief (4) on the lower handle hoop
(6).
Secure the control cable (16) and the power cable (17) on
the handle hoop using the cable clips (5). Make sure that
the cables have enough free motion. Secure the cable
clips using the supplied screws (2xSt 4.2 x 13).
Hoeing spur
Pull out the circlip (18) and turn the axle upwards until the
frame (19) engages audibly.
Secure the hoeing spur (15) on the frame (19). For this,
use the supplied fasteners (2x screw M6x25, 2x thumb nut
M6).
Order number
381883
381886
-
381858
380953
381884
-
381906
381854
381885
381887
381859
381896
381860
381897
381888
381889
-
-
-
-
381891
380954
-
381910
381911

Assembly

17