NOMA Ciara 052-9299-2 Guide D'utilisation page 10

Toll-free: 1-866-827-4985 · model no. 052-9299-2
3.3 Securing Downrod Assembly
Raise the canopy.
Loosen the two downrod set screws on the
coupling (fig. 9).
Insert the downrod into the coupling. Make sure to
align the holes of these two parts.
Install the peaked pin through the aligned holes and
secure it with the clip.
Tighten the two downrod set screws on the coupling
(fig. 9).
4. Wiring Instructions
If you choose to install another light kit, it must be a UL
Listed light kit accessory marked suitable for use with this
fan. Follow the instructions packed with the light kit.
If you feel that you do not have enough electrical wiring knowledge
or experience, have your fan installed by a licensed electrician.
Follow the steps below to connect the fan to your household
wiring. Use the plastic wire splice connectors (BB) supplied with
your fan. Secure the connectors with electrical tape. Make sure
there are no loose strands or connections.
Connect the fan supply (black) wire and light supply (blue)
wire to the black household wire as shown in Figure 8. Do
not connect the blue wire if the light kit is not used.
Connect the neutral fan (white) wire to the white neutral
household wire.
Connect the fanground wires (green) on the mounting plate
and the downrod assembly to the household ground wire.
After connecting the wires, secure the wire connectors (BB)
with black electrical tape and spread them apart so that
the green and white wires are on one side of the outlet box
and the black and blue wires are on the other side. (i.e.,
grounded conductor on one side and hot wires on the other
side.)
Turn the wire connectors (BB) upward and push the wiring
into the outlet box.
If you wish to control the light from a wall switch and the fan from
the pull chain switch or if you wish to control both fan and light
from wall switches, refer to the wiring diagrams in Figures 9 and 10.
9
Clip
Peaked
pin
Figure 8
Diagram indicates light kit wiring
White
Figure 9
Diagram indicates optional wiring
White
Figure 10
Diagram indicates optional wiring
Screw
Ground
Conductor
Outlet Box
Green
Ground Lead
Ground
Conductor
Outlet Box
Green
Ground Lead
Ground
Conductor
Outlet Box
Green
Ground Lead