Operation; Cancelling And Resetting The Programme; Start Delay - Candy GO DC 36 Mode D'emploi

40005088Eng.qxd 30/06/2007

Operation

1. Open the door and load the drum with laundry. Ensure that garments do
not hinder closure of the door.
2. Gently close the door pushing it slowly until you hear the door 'click'
shut.
3. Press the 'Marche Arrêt' button to switch on the dryer. The indicator will
light up and the START indicator will flash.
4. Turn the Programme Selector dial to select the required drying
programme (see Programme Guide).
5. If drying synthetics, acrylics or delicate items, press the 'Séchage Délicat'
button to reduce the heat level.
The light above the push button will light up when the machine is in low
heat setting. To deselect this status when the drying cycle has started it is
necessary to reset the machine.
6. Press the 'Départ' button. The dryer will start automatically and the
START indicator will be continuously lit.
7. The
remaining.
8. If the door is opened during the programme to check the laundry, it is
necessary to press 'Départ' to recommence drying after the door has
been closed.
9. When the 15' indicator is lit the machine will enter the cool down phase,
the clothes will be tumbled in cool air allowing the load to cool down.
10. When the programme is complete the STOP indicator will light.
Cancelling and resetting the
programme
To cancel a programme press the 'Départ' button for 5 seconds. The machine
will indicate that it has been reset by the START indicator flashing. It is
possible to change the programme within the first 10 minutes without using
the cancel and reset function.

Start Delay

The 'Départ Différé' function allows the user to delay the start of the drying
cycle by 6 or 9 hours.
When the function is first selected the display will show a delay of 6 hours, a
subsequent press of the button will increase the delay to 9 hours.
16
17:52 Page 16
display will show the drying progress in terms of time