MSI MEG X570 GODLIKE Présentation Rapide page 35

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3. Each M.2 slot is equipped with one standoff. To avoid damage to the M.2 SSD. If
your M.2 SSD length is the same as the M.2 SHIELD FROZR heatsink, remove the
standoff below the M.2 SSD slot.
4. There are two thermal pads on each M.2 slot base plate. The thermal pad-2 is
fixed on the M.2 Plate and should not be removed.
For double-side M.2 SSD, completely remove the thermal pad-1 and protection
films.
For single-side M.2 SSD, remove the two thermal protection films from pad-1,
then re-stick it to the thermal pad-2.
8.5H screw
Standoff
Thermal pad-1
Thermal pad-2
M.2 Plate
Important
Pictures shown are for illustration purpose only and may differ from the actual plates
and thermal pads.
5. Move the position of the standoffs according to your M.2 SSDs length if need.
6. Insert your M.2 SSDs into the M.2 slots at a 30-degree angle.
7. If the M.2 SSD is shorter than the M.2 SHIELD FROZR heatsink, place the 8.5H
screw in the notch on the trailing edge of the M.2 module and tighten it into the
standoff.
4
3
30º
30º
30º
30º
30º
30º
Protecting films
Overview of Components
23

Publicité

Table des Matières
loading

Table des Matières