Hornbach 6828262 Manuel D'installation Et De L'utilisateur page 172

Mounting bracket 2x
(e.g. in concrete)
The mounting brackets
be installed level and about
250 cm above the ground. The
distance between the insides
of the mounting brackets
is 381 cm. Mark the installa-
tion holes (4 x) of the mounting
brackets on the wall.
Caution: The free-standing may
collapse when fixed improperly!
According to your wall type, drill
the holes and insert suitable
plugs (4 x) (see section "Mount-
ing material").
Install the mounting brackets
(2 x) with the pointy side fac-
ing downwards and the curved
side facing upwards. Ensure
they are securely fixed in place.
Mounting the framing backside
After both wall brackets have
been mounted properly you can
fix the awning.
At least two ladders or treads
are required for steps 5 to 11.
Ensure that the ladders/treads
are firmly resting on the ground
so that you cannot fall. Only use
ladders/treads that are suitable
for such assembly work.
Place the framing with the back-
side beam on the wall mounts
and immediately secure with
the following parts: M10 lock-
ing nut , Ø10 washers
nuts and insert the M10x90
full thread bolts through the
entire assembly (2 x).
Ensure the connections are tight
and secure before moving on to
the frontside beam.
172 | ENGLISH
4
must
5
, M10