Domo DO328IP Mode D'emploi page 33

panel.
· Do not use any flammable, acidy or alkaline materials or substances near the device, as this
may reduce the service life of the device and lead to deflagration when the device is turned
on.
· Make sure that the bottom of the cookware does not scrape across the surface of the
ceramic field, although a scratched surface does not impair the use of the device.
· Make sure that the device was properly cleaned before storing it in a dry place.
· Make sure that the control panel is always clean and dry. Do not leave any objects lying on
the hob.
PROBLEM EN SOLUTIONS
PROBLEM
The display does not light up
after connecting the appliance.
The on/off button has been
turned on and the light turned on
but it does not heat.
Heating stops suddenly during
the process.
E3 or E6 error message
E7 or E8 error message
E1, E2, E4, E5 or Eb
www.domo-elektro.be
POSSIBLE CAUSES
▪ Has the appliance been connected
correctly?
▪ Is the button or plug damaged?
▪ Are you using the correct pan?
▪ For other causes, contact the repair
service.
▪ Is the temperature too high?
▪ Is the environment too hot?
▪ Are the ventilation openings
blocked?
▪ Is the timer done?
▪ The appliance has gone into safe
mode. Wait a few minutes and
reconnect the appliance before trying
it again.
Wait a few seconds and press the on/off
button once the temperature of the hob
has returned to normal. The hob will work
normally again.
Turn the appliance off and turn it back on
once the temperature is back to normal.
The appliance will then work as it should.
Contact the repair service.
33
DO328IP