Beper 40.986 Manuel D'instructions page 10

Hair Clipper Use instructions
INSTRUCTION FOR USE
NOTICE
For the first use of the cut clipper, you have to cut a little bit hair.
Before starting hair cut :
– Make sure the hair clipper is clean, without hair or dirt. If necessary distribute a drop of oil between
the blades of the hair clipper and check that it is running smoothly;
– Place a towel around the neck and shoulders of the person having the haircut;
– Seat the person so their head is approximately at your eye level. This allows ease of visibility while
cutting and a relaxed control of the unit;
– Before cutting always first comb the hair so it is tangle free and as it is naturally worn;
– Cut the hair in a relaxed and slow manner. Use short stroked only to work gradually over the entire
head ;
– Always take off a little hair at a time, you can always trim off additional hair later;
– As you work, comb the hair frequently back into the style to which you are cutting;
When cutting with this hair clipper it is better to leave the hair dry, not wet.
USE
Put the switch on to cut hair.
While making slip the adjustable head on the hair clipper it is possible to regulate the cut length. Pull
up to remove it.
Different positions are available for various cut length :
0.8 – 1.1 – 1.4 – 1.7 – 2 mm (without adjustable head) and 3 – 6 – 9 – 12 mm.
Make slip the adjustable head forward to obtain a longer cut, backwards for shortest cut. After cut­
ting, always switch off the hair clipper.
CLEANING
Always unplug the appliance from the socket.
Remove hair after every use, with the provided brush and distribute a drop of oil on the blades. Use
only mineral oil, as the provided oil ; you can also use oil used for sewing machine..
Clean the external part with a soft cloth lightly wet.
TECHINCAL DATA
Non­stop 90 minutes function
8 hours charge
Power supply: DC 2.4V, 12W
Charger power: 230V ~ 50Hz
For any improvement reasons, Beper reserves the right to modify or improve the product
without any notice.
10