Jennair JUIFX15HX Guide D'installation page 25

INSTALLATION
13 Place rear panel against the back of the ice
maker. Route drain pump discharge tube
and drain pump power cord, through the
slot provided on the ice maker back panel.
Connect ice maker to water supply and
14
install ice maker as specified by the
product installation instructions. Check all
connections for leaks.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result
in death, fire, or electrical shock.
Plug in ice maker or reconnect power.
15
Turn on ice maker. Wait for rinsing cycle,
16
approximately 5 minutes, to be sure the ice
maker is operating properly.
INSTALLATION | 25