Jennair JUIFX15HX Guide D'installation page 24

INSTALLATION
INSTALLING THE DRAIN PUMP
(CONT.)
24 | INSTALLATION
#8-32 x 3/8" pump mounting screws
9 Align the 2 screw holes at the rear of the
pump. Use two #8-32 x 3/8" screws,
supplied.
Receptacle of the
drain pump
10
Coil ice maker power cord into a 4"
(10.2 cm) diameter coil. Wrap electrical tape
around the power cord in several places to
keep the cord in a coil. Locate coiled power
cord between the drain pump and side of
enclosure and plug into the receptacle of
the drain pump.
Drain pump power cord,
clamp and screw
Attach the drain pump power cord to ice
11
maker unit side wall with clamp and screw
(removed in Step 7) that was used to attach
ice maker power cord.
Drain tube
Clamp
12 Attach 1/2" I.D. x 10 ft (3 m) drain tube to
pump discharge tube. Tighten with clamp
received with the drain tube.
NOTE: Do not connect outlet end of drain
tube to a closed pipe system to keep drain
water from backing up into the ice maker.