Jennair JUIFX15HX Guide D'installation page 23

INSTALLATION
5/8" hose
Drain
clamp
pump
Install vent tube [5/16" I.D. x 32" (81 cm)] to
4
drain pump reservoir vent. Use one of the
supplied 5/8" small adjustable clamp.
Wiring
Screws
cover
5
Unscrew the screws attaching wiring cover
to the ice maker. Remove wiring cover.
Vent
tube
Cable
tie
Vent
tube
6
Route vent tube through plastic retainer
that is located underneath top deck in open
pump area as shown in the illustration.
Using cable tie, tie the vent tube to the
black suction tube which is located behind
the wiring cover. Secure wiring cover back
in place.
NOTE: Do not overtighten the vent tube, it
may block the airflow through tube.
Plastic
retainer
Remove power cord clamp and ground
7
screw attached to ice maker power cord,
which is mounted to the unit side wall.
Slide drain pump into the ice maker base
8
on the right side. The pump mounting tab
should slip into the rectangular slot in the
ice maker base. It will be necessary to tip
the pump slightly to slip into the slot.
Drain pump power cord,
clamp and screw
Mounting
tab slot
INSTALLATION | 23