Trim Tab With Anode; Tilt Support Lever For Power Trim And Tilt Model - Yamaha Motor F150 Manuel De L'utilisateur

EMU26246

Trim tab with anode

EWM00841
WARNING
An improperly adjusted trim tab could
cause difficult steering. Always test run af-
ter the trim tab has been installed or re-
placed to be sure steering is correct. Be
sure you have tightened the bolt after ad-
justing the trim tab.
The trim tab should be adjusted so that the
steering control can be turned to either the
right or left by applying the same amount of
force.
If the boat tends to veer to the left (port side),
turn the trim tab rear end to the port side "A"
in the figure. If the boat tends to veer to the
right (starboard side), turn the trim tab end to
the starboard side "B" in the figure.
ECM00841
NOTICE
The trim tab also serves as an anode to
protect the engine from electrochemical
corrosion. Never paint the trim tab as it will
become ineffective as an anode.
1. Cap
2. Bolt
3. Trim tab
Bolt tightening torque:
42 N·m (4.28 kgf·m, 31.0 lb·ft)
EMU26342
Tilt support lever for power trim and
tilt model
To keep the outboard motor in the tilted up
position, lock the tilt support lever to the
clamp bracket.
1
2
1. Tilt support lever
ECM00661
NOTICE
3
Do not use the tilt support lever or knob
when trailering the boat. The outboard
motor could shake loose from the tilt sup-
port and fall. If the motor cannot be
trailered in the normal running position,
ZMU07742
use an additional support device to secure
it in the tilt position.
Components
A
B
ZMU07743
31