White-Westinghouse CAMO Tout À Propos De L'utilisation Et L'entretien page 13

PROBLEM
Longer sound • Appliance operates at
levels when
compressor
comes on.
Popping or • Metal parts undergo ex-
cracking sound
when compres-
sor comes on.
Bubbling • Refrigerant (used to cool
or gurgling
sound, like
water boiling.
Vibrating or • Appliance is not level. It
rattling noise.
• Floor is uneven or weak.
• Appliance is touching
The alarm
• Look on the control panel
is sounding
from the con-
trol panel
WATER/MOISTURE/FROST INSIDE APPLIANCE
Moisture forms
• Weather is hot and humid.
on inside walls.
• Door may not be
• Door is opened too often
WATER/MOISTURE/FROST OUTSIDE APPLIANCE
Moisture forms
• Door may not be seating
on outside.
ODOR IN APPLIANCE
Odor in
• Interior needs to be cleaned.
appliance.
• Foods with strong odors
DOOR PROBLEMS
Door will • Appliance is not level. It
not close.
• Floor is uneven or weak.
LIGHT BULB IS NOT ON
Power Avail-
• LED may be burned out.
able Light is
• No electric current is
not on
• The door has been left open
CAUSE
higher pressures during
the start of the ON cycle.
pansion and contraction, as
in hot water pipes.
the appliance) is circulating
throughout the system.
rocks on the floor when it
is moved slightly.
Appliance rocks on floor
when it is moved slightly.
the wall.
to determine which indica-
tor light is on (High Temp,
Power Fail, or Door Ajar)
seating properly.
or too long.
properly, causing cold air
from inside to meet warm
air from outside.
are in the appliance.
rocks on the floor when it
is moved slightly.
Appliance rocks on floor
when it is moved slightly.
reaching the appliance.
for more than 5 minutes.
BEFORE YOU CALL
CORRECTION
• This is normal. Sound will level off or dis-
appear as appliance continues to run.
• This is normal. Sound will level off or dis-
appear as the appliance continues to run.
• This is normal.
• Level the unit. Refer to "Leveling" in the
INSTALLATION Section.
• Ensure floor can adequately support the ap-
pliance. Level the appliance by putting wood
or metal shims under part of the appliance.
• Re-level or move the appliance slightly. Refer
to "Leveling" in the INSTALLATION Section.
• Press the "set" button to acknowledge the
alarm or close the door if the door ajar
indicator is shown.
• The rate of frost buildup and internal
sweating increases. This is normal.
• See "DOOR PROBLEMS".
• Open door less often.
• See "DOOR PROBLEMS".
• Clean interior with sponge, warm water,
and baking soda.
• Cover the food tightly.
• This condition can force the cabinet out
of square and misalign the door. Refer to
"Leveling" in the INSTALLATION Section.
• Level the floor by using wood or metal
shims under the appliance or brace floor
supporting the appliance.
• Contact a qualified service dealer.
• See "Appliance does not run" in
"APPLIANCE OPERATION".
• Close the door.
13