Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
Electrical Connection
•
This keg cooler requires a standard 115 volt, 60Hz electrical outlet with three-prong ground receptacle. The cord
should be secured behind the keg cooler and not left exposed or dangling to prevent accidental injury.
•
Never unplug the keg cooler by pulling the power cord. Always grip the plug fi rmly and pull straight out from the recep-
tacle.
WARNING
CO
cylinders contain high-pressure compressed gas which can be hazardous if not handled properly.
2
Make sure you READ and UNDERSTAND the following procedures for CO
LATION.
1. ALWAYS connect the CO
the cylinder valve is opened.
2. NEVER connect the CO
3. ALWAYS follow correct procedures when cylinders are changed as per local codes.
4. ALWAYS secure the CO
5. NEVER drop or throw a CO
6. ALWAYS keep CO
cylinder away from heat. Store extra cylinders in a cool place (preferably 70°F/21°C). Securely
2
fasten with a chain in an upright position when storing.
7. ALWAYS ventilate and leave the area immediately if CO
8. ALWAYS check the D.O.T. test date on the cylinder neck before installation. If over fi ve (5) years, do not use, return
cylinder to gas supplier.
9. NEVER connect a keg without a safety pressure release.
•
One at or on the CO
2
•
One at or on the product coupler or in the pressure gas line.
Beer Keg Installation Instructions
Keg Installation Sketch
CO
GAS CAN BE DANGEROUS
2
cylinder to a regulator. Failure to do so could result in explosion with possible injury when
2
cylinder directly to the keg.
2
cylinder in an upright position.
2
cylinder.
2
regulator.
Dual Guage
Pressure
Regulator
CO
Tank
2
leakage has occurred.
2
Faucet Assembly
Tower
Clear Hose with Wing Nut
American Sankey
Tap (Coupler)
Keg
Coloured Pressure
Hose
6
cylinders BEFORE INSTAL-
2
Publicité
Table des Matières
Dépannage
