Troubleshooting Guide - Fisher-Price Imaginext Spike The Ultra Dinosaur Mode D'emploi

Problem
No sounds/lights/motion from/on dinosaur
Lights blink on lower tail and/or motion is slow
and sounds are faint
Clicking noise from legs/ four lights blink on the
dinosaur's neck
Dinosaur does not react to remote control
Dinosaur's eyes are closed and there are no
sounds (but dinosaur and remote control
switches are on)
Dinosaur operates erratically
9.6V NiMH rechargeable battery pack feels warm
ICES-003
This Class B digital apparatus complies with Canadian ICES-003. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference and (2) this device must accept any interference received, including interference that may cause undesired operation.
e TROUBLESHOOTING GUIDE
Solution
• Dinosaur power is not on. Slide the power/volume switch on the dinosaur on.
• Dinosaur is asleep. Press the red button on the dinosaur's back to wake him up.
• 9.6V NiMH rechargeable battery pack power is weak. Remove the battery pack from the battery
compartment on the dinosaur and charge for 4 hours.
• 9.6V NiMH rechargeable battery pack power is weak. Remove the battery pack from the
dinosaur and charge for 4 hours.
• The legs are designed with a clutch if the dinosaur legs or head bump into an obstacle. Simply
remove the obstacle and/or place the dinosaur in another location. Press the red button on the
dinosaur's back to resume play.
• Remote control power is not on. Slide the power switch on.
• If L.E.D. on remote control lights when you press a button, power is off on dinosaur. Slide the
dinosaur power switch on.
• If L.E.D. on remote control does not light when you press a button, battery power in the remote
control is weak. Remove and replace the batteries with three "AA" (LR6) alkaline batteries.
• If L.E.D. on remote control lights when you press a button, you may be out of range of the dinosaur.
Make sure the remote control is no further than 4,6 M (15 feet) from the dinosaur and pointed at
the dinosaur.
• Bright sunlight or fluorescent light may affect the range of the remote control. Try dimming the light
in the room.
• Dinosaur is in sleep mode. Press the red button on the dinosaur's back.
• 9.6V NiMH rechargeable battery pack power is weak. Remove the battery pack from the dinosaur
and charge for 4 hours.
• Electronics need to be reset. Slide the power/volume switch on the dinosaur off and then back
on again.
• It is normal for battery to get warm during charging and is not reason for concern.
9