Before Starting The Equipment; Fitting The Grass Box; Adjusting The Cutting Height; Operation - Tonino Lamborghini EL 4218 TL Traduction Du Mode D'emploi D'origine

Before starting the equipment

The lawn mower is delivered unassembled. The com-
plete push bar and the grass collector must be assem-
bled before using the lawn mower. Follow the operating
instructions step-by-step and use the pictures provided
as a visual guide to easily assemble the machine.
Assembling the handle
a) Assembling the bottom part of the handle
(Fig. 2 and 3)
Align the bottom part of the handle (5) with the brackets.
Make sure that the holes in the handle section match up
with the holders in the brackets, and secure the handle
section in the brackets with the thumb screws (11).
Assembling the top part of the handle and the quick-
release lever (Fig. 4 + 5)
- Position the top handle section on the bottom handle
section.
- Insert the quick-release lever (10) with washer through
the holes in the top and bottom handle sections.
- Tighten the wingnuts (9) by hand.
- Gently push down the quick-release lever (if necessary
loosen or tighten the wingnuts slightly).
Attach the cable to the handle with the cable clips (14)
(Fig. 6).
b) Fitting the grass box
Assembly of Grass box
Take the components and mount the grass cover handle
(12) (Fig. 7 and 8).
Lift the safety guard (13) (Fig. 9). Locate fully assembled
grass box onto location points at the rear of the deck (Fig.
10).
c) Adjusting the Cutting Height
Important!
Adjust the cutting height only when the engine is switched
off and the power cable has been disconnected.
Before you begin to mow, check to ensure that the blade
is not blunt and that none of the fasteners are damaged.
To prevent any imbalance, replace blunt and/or damaged
blades. To carry out this check, first switch off the motor
and pull out the power plug.
Height of cut is adjusted by raising or lowering the Front
and Rear wheels.
Confirm lock and simultaneously set the required height
by either pulling or pressing on the lever (15). When re-
leasing the lock, the setting selected snaps into place.
There are six heights of cut on this product.
NOTE
A medium height of cut is recommended for most lawns.
The quality of your mowing will suffer and collection will
be poor if you cut too low.
GB | Operating Instruction
(Fig. 7 to 10)
(Fig. 11)
Position
1
2
3
4
5
6

Operation

Before you connect the equipment to the mains supply
make sure that the data on the rating plate are identical
to the mains data. Connect the plug (Fig.1/Item 1) to an
extension cable. It is imperative to secure the extension
cable with the cable grip as shown in Figure 1-item 4.
Important!
To prevent the machine switching on accidentally, the
lawn mower is equipped with a safety lock-off (Fig. 12/
Item B) which must be pressed before the switching
bar (Fig. 12/Item A) can be activated. The lawn mower
switches itself off when the switch is released.
Repeat this process several times so that you are sure
that the machine functions properly.
Before you perform any repair or maintenance work on
the machine, ensure that the blade is not rotating and
that the power supply is disconnected.
Repeat this process several times so that you are sure
that the machine functions properly. Before you perform
any repair or maintenance work on the machine, ensure
that the blade is not rotating and that the power supply
is disconnected.
Important!
Never open the discharge flap if the grass box is being
emptied and the motor is still running. The rotating blade
can cause serious injuries.
Always secure the discharge flap and grass bag care-
fully. Always switch off the motor before you remove
these items.
The safety distance between the blade casing and the
user provided by the guide struts must be maintained at
all times. Take special care when mowing and changing
direction on embankments and slopes. Ensure that you
have a secure surface to stand on, wear shoes with anti-
slip soles that offer good grip, and long trousers. Always
mow across the slope (not in up or down direction).
Do not use the mower on gradients exceeding 15° for
safety reasons.
Take special care when moving backwards and pulling
the lawn mower. Danger of stumbling.
a) Information on correct mowing
We recommend that you mow in overlapping lines. Only
mow with sharp, perfect blades so that the blades of
grass do not fray, making the lawn turn yellow.
6
Cutting depth
70 mm
58 mm
48 mm
38 mm
28 mm
20 mm