Jenn-Air JDB9800CWS Mode D'emploi page 20

PROBLEM
THE CLEAN LIGHT IS
FLASHING
INTERIOR TUB LIGHTS DO
NOT COME ON.
20
RECOMMENDED SOLUTION
Check the following:
■ Is the overfill protection float able to move up and down freely? Press down to release.
■ Be sure the water supply is turned on to the dishwasher. (This is very important following the
new installation of your dishwasher.)
■ Check for suds in the dishwasher. If foam or suds are detected by the dishwasher sensing
system, the dishwasher may not operate properly or may not fill with water.
Suds can come from:
■
Using the incorrect type of detergent, such as laundry detergent, hand soap, or dish
detergent for hand washing dishes.
■ Forgetting to replace the rinse aid dispenser cap after filling (or refilling) the rinse aid.
■ Using an excessive amount of dishwasher detergent.
Tub lights are not user serviceable. Call for Service.