Jenn-Air JDB9800CWS Mode D'emploi page 18

PROBLEM
CYCLE RUNS TOO LONG
DISHWASHER NOT DRYING
WILL NOT FILL
WATER REMAINS IN THE
TUB/WILL NOT DRAIN
HARD WATER
(WHITE RESIDUE ON
DISHWASHER INTERIOR OR
GLASSWARE)
ODORS
NOISY
18
RECOMMENDED SOLUTION
NOTES:
■
To use less water and reduce energy consumption you will encounter cycles that typically run for
up to 3 hours.
■ A water heater setting of 120°F (49ºC) is best, the dishwasher will delay longer while heating
cooler water.
■ Some options will add time to the cycle. See "Cycle and Option Descriptions" section. The
Precision Dry ® or Precision Dry
Try the 1 Hour Wash cycle.
Run the hot water at a faucet close to the dishwasher before starting the cycle.
NOTE: Plastic and items with nonstick surfaces are difficult to dry because they have a porous
surface which tends to collect water droplets. Towel drying may be necessary.
Use of rinse aid along with the Precision Dry
Proper loading of items can affect drying. See specific loading instructions within this guide.
Glasses and cups with concave bottoms hold water. This water may spill onto other items when
unloading.
■
Unload the bottom rack first.
■ Locate these items on the more slanted side of the rack for improved results.
Be sure the water is turned on to the dishwasher.
Check that the overfill protection float is free from obstructions. See "Parts and Features" to identify
the location of the float.
Check for suds in the dishwasher. If foam or suds are detected, the dishwasher may not operate
properly or may not fill with water. See "BLINKING LIGHTS" in "Troubleshooting."
Be sure the cycle has completed (the Clean light is on). If it has not, you will need to resume the
cycle by closing the door and pressing START/RESUME.
If dishwasher is connected to a food waste disposer, be sure the knockout plug has been removed
from the disposer inlet.
Check for kinks in the drain hose.
Check for food obstructions in the drain or disposer.
Check your house fuse or circuit breaker.
NOTE: Extremely hard water mineral deposits can cause damage to your dishwasher and make it
difficult to achieve good cleaning. A water softener is strongly recommended if your hardness is
15 grains or more. If a water softener is not installed, the following steps may help:
Use affresh ® dishwasher cleaner to remove buildup from dishwasher and dishware once per month.
Clean the upper and lower filters at least once per month. See Cleaning Instructions in "Filtration
System" section.
Always use a rinse aid.
Always use a high-quality, fresh detergent.
Use a detergent booster/water softener additive designed for dishwashers.
NOTE: If the dishwasher is not used daily, you can run a Refresh/Rinse cycle with the partial load
until a full load is ready to run, or use the Top Rack Only option (on some models) for partial loads.
Run a vinegar rinse through the dishwasher by putting 2 cups (500 mL) of white vinegar in an upright
glass measuring cup in the lower rack. Run a normal cycle with the Heat Dry option turned off. Do
not use detergent.
The dishwasher may not be draining properly, see "WATER REMAINS IN THE TUB/WILL NOT
DRAIN" in "Troubleshooting."
NOTES:
■ Surging sounds can occur periodically throughout the cycle while the dishwasher is draining.
■ Normal water valve hissing may be heard periodically.
■
A normal snap sound may be heard when the detergent dispenser opens during the cycle and
when the door is opened at the end of the cycle.
■ Improper installation will affect noise levels.
Be sure the filters are properly installed.
A thumping sound may be heard if items extend beyond the racks and interfere with the wash arms.
Readjust the dishware and resume the cycle.
® + option adds approximately ½ hour.
® ®
or Precision Dry + option is needed for proper drying.