Main parts (image A)
1
'Hook and loop' sticker
2
Pro microphone with noise cancelling
3
Call button
4
USB charging port (3.0 A)
5
LED display
Safety instructions
WARNING
-
•
Ensure you have fully read and understood the instructions in this document
before you install or use the product. Keep this document for future
reference.
•
Only use the product as described in this document.
•
Do not use the product if a part is damaged or defective. Replace a damaged
or defective product immediately.
•
Do not drop the product and avoid bumping.
•
This product may only be serviced by a qualified technician for maintenance
to reduce the risk of electric shock.
•
Do not expose the product to water or moisture.
•
Disconnect the product from the power source and other equipment if
problems occur.
•
Do not expose the product to direct sunlight, naked flames or heat.
•
Do not place the product near heat sources, this can damage the product.
•
Do not expose the product to very hot or very cold temperatures or drastic
changes in temperature or humidity.
•
Do not immerse the product in water for cleaning.
•
Be careful when using the product while driving. Always focus your attention
on the road.
Installing the product (image B)
1. Plug the auxiliary power plug A
The LED display A
"BT" to indicate Bluetooth pairing mode is active second.
2. Attach the pro microphone with noise cancelling A
1
Use A
.
q
5
shows the voltage of the battery of the car first and shows
6
USB music port (1.0 A)
7
Next button
8
Previous button
9
Frequency button
10
Auxiliary power plug
into an auxiliary power outlet.
2
5
to your car dashboard.