Operation; Starting The Engine - Briggs & Stratton 30545 Manuel D'utilisation

Operation

Starting the Engine

Disconnect all electrical loads from the generator. Use the
following start instructions:
1. Make sure unit is on a level surface.
NOTICE Failure to start and operate the unit on a level
surface will cause the unit not to start or shut down during
operation.
2. Turn the engine switch (A) to the ON (I) position.
3. Push choke lever (B) to CHOKE (
B
NOTICE To help start the engine for the very first time, after
running out of fuel or after a long period of storage, fill fuel
tank as described in Add Fuel. It will require more than
several start attempts until the air in the fuel system has
been purged.
4A. Grasp recoil handle and pull slowly until slight resistance
is felt. Then pull rapidly to start engine.
• If engine starts, proceed to step 6.
• If engine fails to start, proceed to step 5.
WARNING Starter cord kickback (rapid retraction)
will pull hand and arm toward engine faster than
you can let go which could cause broken bones,
fractures, bruises, or sprains resulting in serious
injury.
• When starting engine, pull cord slowly until resistance is felt
and then pull rapidly to avoid kickback.
• NEVER start or stop engine with electrical devices plugged in
and turned on.
To start engine thereafter:
4B. Grasp recoil handle and pull slowly until slight resistance
5. Move choke lever to half choke position, and pull recoil
6. Slowly move choke lever to RUN (
NOTICE If engine floods, move choke lever to RUN (
A
position and crank until engine starts.
NOTICE If engine starts after 3 pulls but fails to run, or if
unit shuts down during operation, make sure unit is on a
level surface and check for proper oil level in crankcase. This
unit is equipped with a low oil protection device. If so, oil
must be at proper level for engine to start.
) position.
Contact with muffler area could cause burns resulting in
serious injury.
• DO NOT touch hot parts and AVOID hot exhaust gases.
• Allow equipment to cool before touching.
• Keep at least 5 feet (1.5 m) of clearance on all sides of
• It is a violation of California Public Resource Code, Section
• Replacement parts must be the same and installed in the same
is felt. Then pull rapidly one time only to start engine.
• If engine starts, proceed to step 6.
• If engine fails to start, proceed to step 5.
handle twice.
• If engine fails to start, repeat steps 3 thru 4.
engine falters, move choke lever to half choke position
until engine runs smoothly, and then to RUN (
position.
WARNING Exhaust heat/gases could ignite
combustibles, structures or damage fuel
tank causing a fire, resulting in death or
serious injury.
generator including overhead.
4442, to use or operate the engine on any forest-covered,
brush-covered, or grass-covered land unless the exhaust
system is equipped with a spark arrester, as defined in Section
4442, maintained in effective working order. Other states or
federal jurisdictions may have similar laws.
Contact the original equipment manufacturer, retailer, or dealer
to obtain a spark arrester designed for the exhaust system
installed on this engine.
position as the original parts.
) position. If
)
)
17